CCNA Practice Quiz: 200-301 Quiz 27

1. One of the steps in the password recovery process for a router is to access the ROM monitor. Which of the following methods will accomplish this? (Choose two)

• Remove the external flash memory while the device is powered off and then boot
• Run the confreg 0x2102 command
• Boot into the BIOS
• Use a break sequence during the boot process
• Run the confreg 0x2142 command

2. Which of the following commands would you use to modify the CDP packet exchange interval to send CDP packets every 30 seconds?

• cdp interval 30
• cdp exchange 30
• cdp broadcast 30
• cdp timer 30
• cdp holdtime 30

3. Which of the following are components of a Link-State Routing Protocol? (Choose three)

• Routing table of paths and ports
• Split horizon loop avoidance
• Hold-downs
• Triggered updates
• Hello packets
• SPF tree
• Poison reverse

4. Last night, an administrator connected a new router to his network and enabled the RIP routing protocol. This morning, when the administrator returned, he discovered the router wasn't forwarding packets to networks connected to the Serial1 interface. He examines the routing table using the command show ip route.

What could be the cause of the problem?

• This network must use the IGRP routing protocol.
• A default route is not configured.
• The Serial1 interface is administratively shut down.
• The RIP routing protocol is not working.

5. You are an administrator of a growing network. The network you have created is broadcasting, but you cannot ping systems on different segments of your network. Which device should you use to fix this issue?

• Range extender
• Access point
• Network bridge
• Network hub

6. Which of the following enterprise wireless deployment models uses access points with enough intelligence to allow the creation of guest WLANs for keeping public wireless traffic separate from private traffic?

• Hub-and-spoke infrastructure
• Independent access points
• Distributed wireless mesh infrastructure
• Lightweight access point (LWAP) with wireless controller infrastructure

7. Which component is responsible for collecting and consolidating data from network devices that are being monitored with SNMP?

• SNMP Management Information Base (MIB)
• SNMP Agent
• SNMP Manager
• SNMP Management Information File (MIF)

8. Which SNMPv3 security level requires MD5 or SHA authentication and implements DES encryption?

• Community Name
• authPriv
• authNoPriv
• noAuthnoPriv

9. Analyzing emails, suspect files, and systems for malware is known as which of the following?

• Integrity checking
• Dynamic analysis
• Sheep dipping
• Static analysis

10. Daphne has determined that she has malware on her Linux machine. She prefers to only use open-source software. Which anti-malware software should she use?

• Avira
• Kaspersky
• ClamAV
• Bitdefender