Skip survey header

CCNA Practice Quiz: 200-301 Quiz 22

Enjoy the following 10 question quiz from TestOut.

1. You want to prevent users from accessing a router through a Telnet session. What should you do?
2. You want users to enter a password before being able to access the router through a Telnet session. You use the following commands:

router#config t
router(config)#line vty 0 4
router(config-line)#password cisco
router(config-line)#exit
router(config)#exit 


You open a Telnet session with the router and discover that the session starts without being prompted for a password. What should you do?
3. You are the only network administrator for your company. You are planning for an upcoming vacation, and you need to ensure that you can administer your switches remotely while you are gone. What must you configure to allow remote administration? (Choose two)
4. IP traffic destined for a device configured with the address 10.10.34.4/24 is congesting the network. The network administrator issues a traceroute command from the local router and receives the following output:

Router#traceroute 10.10.34.4

Type escape sequence to abort.
Tracing the route to 10.10.34.4

  1 192.168.12.2 20 msec 20 msec 20 msec
  2 192.168.12.1 8 msec 12 msec 8 msec
  3 192.168.12.2 8 msec 8 msec 12 msec
  4 192.168.12.1 12 msec 8 msec 8 msec
  5 192.168.12.2 8 msec 8 msec 12 msec
  6 192.168.12.1 8 msec 12 msec 8 msec
! -- remaining output omitted -- 


What is the cause of the problem?
5. To properly configure link-state routing, which of the following is mandatory within an area?
6. You want to prevent all interfaces on a router from sending or responding to OSPF Hello messages. Which command should you use?
7. Which command disables the trunking configuration on a switch interface?
8. You want to verify that trunking is enabled between the Catalyst 2950XL switch and the Cisco 2600 router. Which command must you enter?
9. A programmer wants to communicate with a software application on a controller. Which of the following would the programmer use?
10. Which data format is the following snippet in?

< root >
< message > success < / message > < timestamp > 1560789260 < / timestamp >
< iss_position >
   < latitude > 25.9990 < / latitude >
   < longitude > -132.6992 < / longitude > < / iss_position >
< / root >
This free quiz was provided by: