CCNA Practice Quiz: 200-301 Quiz 11

1. While working at the console of a Cisco device, you need to view a list of the commands that are currently stored in the history buffer of the system. Which command should you use?

• terminal editing
• terminal no history
• ?
• show history
• terminal history

2. You want to look at the configuration register. Which command would you use?

• show flash
• en flash
• config flash
• run flash

3. Which protocol is well known for its use in the home security and home automation industry, uses a mesh topology, makes devices act as repeaters, and has a low data transfer rate?

• Ant+
• 802.11 AC
• NFC
• Z-Wave

4. Which protocol was created in the 1980s, was improved over the years, and is still used for small networks?

• OSPF
• RIP
• IS-IS
• IGRP

5. Which process do routers use to select the best path when multiple route possibilities are available?

• Link-state advertisement
• Cost
• Network topology
• Administrative distance

6. You need to view the configuration settings of an interface on your router to see if it can send or respond to OSPF Hello messages. Which command should you use?

• no ipv6 unicast-routing
• show ipv6 route
• show passive-interfaces
• show ip ospf interface

7. While configuring a new 802.11g wireless network, you discover another wireless network within range that uses the same channel ID that you intend to use. Which of the following strategies are you most likely to adopt in order to avoid a conflict between the networks?

• Use the same channel ID but configure a different SSID.
• Use the same channel ID but configure your wireless network to use WEP.
• Use 802.11b instead of 802.11g.
• Use a different channel ID.

8. When implementing a Multiprotocol Label Switching (MPLS) WAN, which data unit is managed by the routers at different sites?

• Datagrams
• Frames
• Bits
• Packets

9. You have a Layer 3 switch that is capable of interVLAN routing. Which process must you complete to allow interVLAN routing on a Layer 3 switch interface?

• Configure the interface as a switch virtual interface.
• Configure link-state routing, such as OSPF or EIGRP.
• Implement a three-tier network design with Access layer, Distribution layer, and Core layer switches.
• Configure Spanning Tree Protocol (STP) to prevent interVLAN looping.

10. A 5-port hub is attached to interface fa 0/1 on your switch. Users of the workstations attached to the hub are complaining that their pings are erratic. When you run the show interfaces fa 0/1 command, you receive the following output:

FastEthernet0/1 is up, line protocol is up (connected)
   Hardware is Fast Ethernet, address is 0019.e744.7401 (bia 0019.e744.7401)
   MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
      reliability 255/255, txload 1/255, rxload 1/255
   Encapsulation ARPA, loopback not set
   Keepalive set (10 sec)
   Full-duplex, 100Mb/s, media type is 10/100BaseTX

What is the problem?

• FIFO queuing strategy
• 100Mb/s port
• Duplex mismatch
• Giant packets