CCNA Practice Quiz: 200-301 Quiz 10

1. Which two of the following statements accurately describe full-duplex Ethernet? (Choose two)

• It uses built-in loopback and collision detection.
• It is collision-free.
• It uses 75 percent of the available bandwidth for actual signal transmission.
• It multiplexes signals along the same wire for higher transmission speeds.
• It uses direct point-to-point connections between the sender and receiver.

2. You are asked to design a LAN segmentation solution for Company AGH. They have three workgroups separated with VLANs: Accounting, Sales, and Service. Most network traffic is localized within the individual workgroups, but some traffic crosses between each group. Company AGH is especially concerned about the security of information within the Accounting department.

Which segmentation device meets the functionality requirements and provides the simplest, most economical administration?

• Switch
• Bridge
• Hub
• Router

3. While working at the console of a Cisco device, you need to use the same command repeatedly. Given that the command is quite long, what can you do to avoid having to retype it over and over?

• Enter "terminal no history" at the command prompt.
• Enter "terminal editing" at the command prompt.
• Enter "show history" at the command prompt.
• Press the Up arrow key.

4. Which command would you use to remove the contents of NVRAM?

• wipe nvram
• clear nvram
• erase nvram
• delete nvram

5. You have just entered the configure terminal on a router and specified a gigabit interface. You want to disable CDP on that interface, but you want to keep CDP enabled on the device. Which of the following commands would you use?

• Router(config)#no cdp
• Router(config)#cdp run
• Router(config)#no cdp run
• Router(config)#no cdp enable

6. Which of the following protocols enables Cisco devices to discover non-Cisco devices?

• CDP
• DCBXP
• LLDP
• TLV

7. You have a Cisco router connected to a local ISP. The ISP dictates that the router use DHCP to receive its IP address and other configuration information. Which command should you use when configuring the ISP interface on the router?

• ip dhcp-client
• ip dhcp database
• ip address dhcp
• ip dhcp-server

8. Which database lists the best possible route calculated from the SPF?

• Topology
• Routing table
• Adjacency
• Summary

9. Which algorithm does a router use to calculate all routes for a subnet?

• SPF
• BGP
• LSA
• Cost

10. An access point that conforms to the IEEE 802.11ac standard handles network traffic similarly to which other networking device?

• Hub
• Router
• Terminal
• Gateway